Every day a unit sits empty costs rent. This checklist walks a unit in the order the work usually happens, so nothing gets missed and the trades are not in each other's way.
1. Walk it and document it
- Photograph every room, wall and floor before anything is touched, for the deposit file.
- Note damage beyond normal wear room by room.
- Write down the move in date. Everything else is planned backwards from it.
2. Repairs first
- Patch holes in drywall, including anchors from TVs and shelves.
- Check every door: it latches, the hardware is tight, and stops are in place.
- Replace damaged trim and baseboards.
- Recaulk tubs, showers and sinks where caulk is cracked or stained.
3. Paint
- Use one standard wall color and sheen across your units, so touch ups between tenants match.
- Use a washable finish like eggshell or satin in halls and bedrooms, and semi gloss on trim and doors.
- Paint before new flooring goes down, so drips land on the old floor.
4. Floors
- Replace worn carpet in high traffic rooms. Vinyl plank holds up to water, pets and furniture, and single planks can be swapped later.
- Clean or replace transitions between rooms.
- Measure before you order; the flooring guide shows how.
5. Kitchen and bath
- Run every faucet and check under the sinks for leaks.
- Check cabinet doors and drawers for damage and loose hinges.
- Look at grout and tile for cracks that let water through.
6. Safety and final checks
- Test smoke and carbon monoxide alarms, and replace batteries as your lease and local codes require.
- Replace burned out bulbs and filters.
- Rekey or change the locks.
7. Photos for the listing
- Shoot in daylight with the lights on, after the cleaners are done.
- Take one wide photo of each room from the doorway.
Need it done by a date?
Send the address, the move in date and the scope through the realtor and property manager request form, and DK will confirm whether the date works.